HPgate, developed by the Italian hot runner specialist HRSflow, is a new, quality-enhancing, cost-saving valve gate solution for manufacture of high-quality parts without flash. 

Compared to the conventional versions, the gate is machined on an hardened metal insert produced by HRSflow itself. This insert is simply screwed into the mold, so it’s very easy to replace it in the event of wear. 

This innovative solution saves the moldmaker the time-consuming and complex machining of the standard cylindrical gate. Infact with the gate geometry already being machined on the insert, the HPgate from HRSflow eliminates the difficulties connected with the cylindrical configuration including narrow tolerances, large and variable depths and providing coaxiality between needle and gate. Equally beneficial for the moldmaker is the outstanding hardness of the insert, because of which a less hard steel could also be chosen for the mold plates. 

Another advantage comes from the special needle geometry in which the conical contact surface allows a better thermal control of the needle temperature, whilst the precisely aligned cylindrical needle closure assumes the task of sealing. With the conventional conical configuration, when the valve closes there is always the formation of the typical plastic layer at the gating point. When the mold opens this layer is torn off from the part and it could lead to flash formation. In order to get a good detachment, so avoiding flash, frequently a very fine adjustment of the process conditions is required. Through the elimination of the layer due to the cylindrical needle closure, the HPgate solution reduces the time required to optimize the respective process parameters. Excellent molding quality is attained much faster, which is basically equivalent to enlarging the process window. 

An even higher gate quality can be obtained by combining the HPgate technology with HRSflow's FLEXflow technology. Here, the needle position can be precisely controlled, thereby reducing even further the influence of the process conditions. The result is high-quality reproducible parts with optimum gate aesthetics.